Electric insert · Legend Flame

Legend Flame EF264A 35-Inch Electric Fireplace Insert

35-inch electric insert, 1,500 W

Heats up to (maker)
400 sq ft
Wattage
1,500 W
Thermostat
adjustable thermostat
Dimensions (seller)
10.4"D x 43.7"W x 30.6"H
Prices change often; the button shows today's price.

Each button opens this exact model. We may earn a commission on tracked links; it never changes what we publish. Disclosure

In short

Pick it for converting an unused fireplace.

Wins
5,118 BTU/h of heat.
Gives ground
Supplemental heat only.
Suits
Converting an unused fireplace.

Updated October 2026

What you get

The Legend Flame EF264A 35-Inch Electric Fireplace Insert is an electric insert with a 1,500-watt heater, which works out to about 5,118 BTU per hour (3.412 BTU per watt).

Its 1,500 watts means 12.5 amps on a household outlet and 1.5 kWh for each hour on high. The fuel cost calculator turns that into your hourly cost.

The maker says it heats up to 400 square feet; as with any 120-volt heater, read that as supplemental heat for one room.

Like most electric fireplaces the flame effect can run with the heater off, using far less power.

As an insert it slides into an existing fireplace opening; measure the opening width, height and depth against the body dimensions, and the face against the trim. How to measure.

Electric fireplaces burn nothing, so they produce no carbon monoxide and need no vent, chimney or gas line.

Also on the listing: overall dimensions of 10.4 in (D) x 43.7 in (W) x 30.6 in (H).

The figures, from the maker

Each figure is the maker's or the listing's own, with its source marked. A figure the maker doesn't give is shown as not stated.

Model numberEF264ARetailer
PowerCorded ElectricRetailer
Dimensions (seller)10.4"D x 43.7"W x 30.6"HRetailer
Mounting / installationFreestandingRetailer
Features (seller)Adjustable FlameRetailer
Batteries2 AAA batteries required.Retailer
Model nameCarlRetailer
Heats up to (maker)400 sq ftRetailer
Wattage1,500 WRetailer
Thermostatadjustable thermostatRetailer

Is it the right heater for the room?

Pick it when

  • Converting an unused fireplace
  • Rooms where gas or wood can't go

Pass on it when

  • Heating a whole house
  • Circuits already near their limit

Where it wins, where it gives ground

Wins

  • 5,118 BTU/h of heat
  • No vent or chimney
  • Flame runs without heat

Gives ground

  • Supplemental heat only
  • Draws 12.5 A on high

Know before you install

  • Figures are the maker's own and are rated in the maker's conditions. Installation, venting, chimney, gas and electrical work follow the manual and local code, carried out by a qualified installer.

Heaters to weigh against it

Other electric fireplaces and stoves in the same heat range

Every electric fireplaces and stoves on one chart · All Legend Flame models listed

Buying this model

The button opens this exact model's listing. Prices and stock change, and installation parts are usually sold separately; check the box contents and the manual's venting list before you order.

Prices change often; the button shows today's price.

Each button opens this exact model. We may earn a commission on tracked links; it never changes what we publish. Disclosure

Questions about this model

How much heat does the Legend Flame EF264A 35-Inch Electric Fireplace Insert give?
About 5,118 BTU per hour on its 1,500-watt setting, since each watt gives 3.412 BTU per hour.
Can the Legend Flame EF264A 35-Inch Electric Fireplace Insert share a circuit?
It draws about 12.5 amps at 120 volts on high, most of a 15-amp circuit; the manual says how to connect it.

Bottom line

Pick it for converting an unused fireplace.